zenyra souza

project

Locking pliers: design and stress analysis, SolidWorks, 2026

Summary

Locking pliers: design and stress analysis, cover image

Modeled a vise grip in SolidWorks, found its most stressed part and proposed changes to strengthen it.

Write-up

For ME 473 I designed and modeled a vise grip (locking pliers) as a SolidWorks assembly, then ran static stress studies in SolidWorks Simulation on two of its parts: the diagonal toggle link and the movable jaw. Both parts are alloy steel with a yield strength of 620.4 MPa.

Results

  • Diagonal toggle link: peak von Mises stress of 154.6 MPa, a factor of safety of about 4.0. The highest stress sits around the loaded pin hole.
  • Movable jaw: peak von Mises stress of 478.1 MPa, a factor of safety of about 1.3. The highest stress sits at the tip where the load is applied.

Both parts stay below yield, but the jaw has little margin, so it gets priority in a redesign.

Proposed changes

  • Add thickness where the jaw is most stressed.
  • Use larger fillets and smoother changes in cross section to cut stress concentrations.
  • Add material around the heavily loaded pin holes where there is room.
  • Remove material from low-stress areas of the link to save weight.
  • Refine the mesh near holes and fillets and check that peak stresses converge.
  • Rerun the study on the changed parts to confirm the improvement.

Gallery